Honeywell touchpoint Pro - PC Configuration Software; SD Card Usage; Communication Interfaces

MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
73
5. User Interface
• Internet explorer 6.0 to 8.0
• Chrome up to V38
• Safari
• Chrome up to V38 on Android devices
5.6 PC Conguration Software
TheoptionalPCCongurationSoftwareisoptimisedforthelargerscreenofaPC,insteadofthelocal
touchscreen. The menu and navigation are as detailed in the section “Menu Structure” however multiple
screens are combined, reducing the overall commissioning time.
Note: the PC Conguration Software is compatible with Windows 7. Please refer to Chapter 6,
Commissioning for the necessary settings.
5.7 SD Card
The SD card is used to store the event history of the system. Touchpoint Pro logs all events and all changes
toinputreadings.AnoticationwillbegivenwhentheSDcardis80%full.Ifthecardisnotreplaced,a
furthernoticationwillbegivenwhenitisfull,andwhendataisbeingoverwritten.
Note: A list of the events that are logged is given in Appendix 7 - Events
Caution: The SD Card must remain inserted during normal system operation. When the card is full it
should be replaced immediately
5.8 Interfaces
The Control Module has several communication interfaces:
• 10/100 Mbps Ethernet port for connection to a local network, to enable the Web Server function and
 optionalPCCongurationSoftware
• Connections for the optional dual RS485 Modbus RTU interface
• AUSBportforconnectiontoaUSBashdrive,whichcanbeusedtosavereports,backup
 andrestoreconguration,andupdatesoftware,rmwareandthesensorcatalogue
Note: The USB Device port is not EMC safe, and is to be used for maintenance mode only. The USB Host
port can take a USB ash drive, which can be left in place provided that it does not foul the cables or
cabinet door.