HP ESG Series - Page 69

3-26
Troubleshooting
Device-Specific Error
-312 PUD memory lost
Indicates that the protected user data saved by the *PUD
command has been lost.
-313
Calibration memory lost
Indicates that non-volatile calibration data has been lost.
-314
Save/recall memory loss
Indicates that the non-volatile data saved by the *SAV?
command has been lost.
-315
Configuration memory lost
Indicates that non-volatile configuration data saved by the
device has been lost. The meaning of this error is
device-dependent.
-320
Storage fault
Indicates that the firmware detected a fault when using data
storage. This error is not an indication of physical damage or
failure of any mass storage element.
-321
Out of memory
Indicates that an internal operation needed more memory than
was available.
-330
Self-test failed
Indicates that the device has detected a failure during its
self-test procedure.
-340
Calibration failed
Indicates that the device has detected a failure during its
calibration procedure.
-350
Queue overflow
This is a specific code entered into the queue in lieu of the code
that caused the error. This message indicates that there is no
more room in the queue and an error occurred but was not
recorded.