269
Figure 277 Configuring an SNMP group
4. Configure an SNMP user:
a. Click the User tab and then click Add. Perform the following configuration as shown in Figure
278.
b. Typ
e user1 in the User Name field.
c. Select Auth/Pri from the Security Level list.
d. Select group1 (Auth/Priv) from the Group Name list.
e. Select MD5 from the Authentication Mode list.
f. Type authkey in the Authentication Password and Confirm Authentication Password fields.
g. Select DES56 from the Privacy Mode list.
h. Type prikey in the Privacy Password and Confirm Privacy Password fields.
i. Click Apply.
Figure 278 Configuring an SNMP user
To Next Page
Loading...
