380
Figure 382 Adding a static route from Router A through interface Tunnel 0 to Group 2
Configuring Router B
1. Configure an IPv4 address for interface Ethernet 0/0:
a. Select Interface Setup > WAN Interface Setup from the navigation tree.
b. Click the icon for interface Ethernet 0/0 and then perform the configurations shown
in Figure 383.
c. Selec
t Manual for Connect Mode.
d. Enter IP address 10.1.3.1.
e. Select IP mask 24 (255.255.255.0).
f. Click Confirm.
Figure 383 Configuring interface Ethernet 0/0
2. Configure an IP address for interface Ethernet 0/1, the physical interface of the tunnel:
To Next Page
Loading...
