Inertial Labs INS-P User Manual

INS
GUI User’s Manual
Inertial Labs, Inc
TM
Address: 39959 Catoctin Ridge Street, Paeonian Springs, VA 20129 U.S.A.
Tel: +1 (703) 880-4222, Fax: +1 (703) 935-8377 Website: www.inertiallabs.com
30
 Vertical position – allows to choose variant of output altitude –
above mean sea level MSL) or above WGS84 ellipsoid.
 GNSS COM Port 2 fields configure COM2 port setting for output
GNSS raw data or NMEA data set:
– Data set – allows choosing desirable set of GNSS receiver data for
output through COM2 port. User can choose GNSS raw data (full or
minimal set) or NMEA set output in the drop-down list (see Fig. 4.5).
When “No” is chosen then no GNSS data are output. Default setting
is “No”.
Fig. 4.5
– Data rate – sets frequency of COM2 port raw GNSS data output.
When Data set is set to “Raw GNSS” or “Min Raw GNSS” user can
choose frequency of data output in the drop-down list (see Fig. 4.6).
See section “12.1. Recording of raw GNSS data” for more details.

Inertial Labs INS-P Specifications

General

Brand	Inertial Labs
Model	INS-P
Category	Car Navigation system
Language	English