6 - 14
HAPSITE ER Operating Manual
5 Click the desired method and then, click OK. This example shows the
ER_Air_Tri-Bed_PPB_Standard.mth method. (See Figure 6-23.)
Figure 6-23 Selecting the Method
6 The software will check the pressure in the gas canisters, heat up all necessary
components and run an AutoTune (if required). A concentrator cleanout will
also be run if needed.
7 When it is finished heating, a prompt will appear to indicate HAPSITE ER is
ready to run a sample. Click RUN. For detailed instructions, refer to section 6.3,
ANALYZE (GC/MS) Mode with the Concentrator, on page 6-6.
Do not place the sample probe in liquids while sampling.
To Next Page
Loading...
