10 - 2
HAPSITE ER Operating Manual
Figure 10-1 Method Profile
Newly created methods start with a default set of Inlet States and a default
Temperature Profile, which can be modified as required by the application.
NOTE: The bottom of each page will display the inlet states, see section 10.6.1,
Inlet States, on page 10-14 for more information, and the temperature
profile, see section 10.6.2, GC Temperature Profile, on page 10-18 for
more information.
To access Method Editor:
1 On the System Setup screen, double-click on the Method Editor icon. See
Figure 10-2.
Figure 10-2 Method Editor Icon
To Next Page
Loading...
