3 - 15
HAPSITE ER Operating Manual
2 The crossover cable has two ends. One end has a screw top on the modular
connector. This end will connect to HAPSITE ER. (See Figure 3-26.)
Figure 3-26 Crossover Cable
3 Plug the modular connector with the screw top into HAPSITE ER port. Screw
the plug into place. (See Figure 3-27.)
Figure 3-27 Modular Connector
4 Plug the opposite end into the laptop. (See Figure 3-28.)
Figure 3-28 Plugging in the Laptop
5 Once connected, the crossover cable communication between HAPSITE ER
and laptop computer will be enabled.
NOTE: To troubleshoot or set up communications for a new laptop, see section
3.2.4, Connecting the Laptop, on page 3-14.
To Next Page
Loading...
