Inficon HAPSITE ER - Attaching HAPSITE to the Service Module

12 - 8
HAPSITE ER Operating Manual
CAUTION
Prior to attaching HAPSITE to the Service Module, unplug
the black NEG cable inside the HAPSITE front panel. This
will ensure that the NEG will not heat when using the
Service Module to provide vacuum.
2 Connect HAPSITE to the computer using wireless communication or the
crossover cable.
3 Open IQ Software.
4 Click the desired HAPSITE sensor icon.
5 Double-click the Service Module icon. (See Figure 12-3.)
Figure 12-3 Service module icon
6 The Service Module tab on the HAPSITE Properties window displays.
7 Click Attach. (See Figure 12-4.)
Figure 12-4 HAPSITE properties window