Chapter 6: Console Configuration
User Defined Panel
336/ 526 2.0 Eclipse User Guide
Remote
This switch can be used action several on/off functions from a
single button press. For example, to switch all your outboard
inserts out of circuit. Or, to switch a group of channel mutes on
or off.
Up to four different Remotes can be configured using the four
switches on the User Defined panel.
To programme the Remote switch’s function:
1. Press and hold the REM switch.
All selected channel displays (EQ, Dynamics, etc.) and SEL
buttons go out across the console.
2. While holding down the REM switch, press the on/off
buttons which you wish to action – for example, press
insert on/off.
3. Then press the SEL buttons on the channels you wish to
add to the Remote group – for example, press SEL on
faders 1 to 8.
Note that you will only be able to select channels if the
processing is valid. For example, you cannot select insert on/off
for a channel which has no insert assigned!
4. Release the REM switch and the assignment is made.
To operate the programmed function:
1. Press the REM switch.
The selected on/off functions on the selected channels are
switched on or off with one button press – in our example, insert
on/off for faders 1 to 8.
You can confirm this by looking at the Main Mix display for any
of the channels in your Remote group.
To Next Page
Loading...
