Chapter 7: Reset and Automation
The Play List (Automation)
Eclipse User Guide 2.0 369/ 526
Sending MIDI Program Changes
When a Page is changed, it is possible to send a MIDI Program
Change so that MIDI devices connected to the console, such as
outboard effects, have their program number updated.
The columns headed 01 to 16 within the Play List manage the
16 MIDI channels:
You can Label each column (up to 4 characters) so that you
can identify a device by its name rather than by channel
number.
To define a program change:
1. Select the Page which will send the program change.
2. In the MIDI channel cell (column 01 to 16), type in the
value of the program change.
You can enter any value from 0 to 127.
3. Confirm by pressing [ENTER].
4. When you have finished, remember to turn on MIDI out
on the Main Mix display, see Page 381.
From here on, your configured program changes will play out
when you change to the relevant Page.
You can also select and send MIDI Program changes from
controls on the User Defined panel, see Page 322.
To Next Page
Loading...
