EasyManua.ls Logo

Juniper JUNOSE 11.2.X BGP AND MPLS

Juniper JUNOSE 11.2.X BGP AND MPLS
742 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Point-to-Multipoint LSPs Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 271
Using E Series Routers as Egress LSRs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 272
Chapter 4 Configuring MPLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 275
Basic MPLS Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 276
MPLS Global Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 277
MPLS Global Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 277
LDP Global Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 278
RSVP-TE Global Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 279
LDP and RSVP-TE Interface Profile Configuration Tasks . . . . . . . . . . . . . . . . . . . 280
LDP Interface Profile Configuration Tasks and Commands . . . . . . . . . . . . . . 281
RSVP-TE Interface Profile Configuration Tasks and Commands . . . . . . . . . 281
MPLS Interface Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 281
MPLS Interface Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
LDP Interface Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
RSVP-TE Interface Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
MPLS Tunnel Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 283
MPLS Tunnel Profile Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 285
Configuring Explicit Routing for MPLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 286
Defining Configured Explicit Paths . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 287
Specifying Configured Explicit Paths on a Tunnel . . . . . . . . . . . . . . . . . . . . . 287
Configuring Dynamic Explicit Paths on a Tunnel . . . . . . . . . . . . . . . . . . . . . . 288
Additional LDP Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 288
Configuring LDP FEC Deaggregation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 288
Configuring LDP Graceful Restart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 289
Configuring LDP Autoconfiguration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 290
Configuring LDP-IGP Synchronization . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 291
Configuring LDP MD5 Authentication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 291
Controlling LDP Label Distribution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 292
Additional RSVP-TE Configuration Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 293
Configuring RSVP MD5 Authentication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 294
Configuring RSVP-TE Fast Rerouting with RSVP-TE Bypass Tunnels . . . . . . . . . 295
Configuration Example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 296
Fast Reroute over SONET/SDH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 297
Configuring RSVP-TE Hello Messages to Determine Peer Reachability . . . . . . . 297
Configuring RSVP-TE Graceful Restart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 298
Configuring RSVP-TE Hellos Based on Node IDs . . . . . . . . . . . . . . . . . . . . . . . . . 299
Configuring the BFD Protocol for RSVP-TE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 300
Configuring IGPs and MPLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 301
Configuring the IGPs for Traffic Engineering . . . . . . . . . . . . . . . . . . . . . . . . . 302
Configuring MPLS and Differentiated Services . . . . . . . . . . . . . . . . . . . . . . . . . . . 303
Configuring the Tunneling Model for Differentiated Services . . . . . . . . . . . . . . . 304
Configuring EXP Bits for Differentiated Services . . . . . . . . . . . . . . . . . . . . . . . . . 304
Example Differentiated Services Application and Configuration . . . . . . . . . . . . . 305
Differentiated Services Configuration Example . . . . . . . . . . . . . . . . . . . . . . 306
Classifying Traffic for Differentiated Services . . . . . . . . . . . . . . . . . . . . . . . . . . . . 307
Configuring Static EXP-to-PHB Mapping . . . . . . . . . . . . . . . . . . . . . . . . . . . 309
Signaled Mapping for RSVP-TE Tunnels . . . . . . . . . . . . . . . . . . . . . . . . . . . . 310
Preference of per-VR Versus per-LSP Behavior . . . . . . . . . . . . . . . . . . . . . . . 312
xvCopyright © 2010, Juniper Networks, Inc.
Table of Contents

Table of Contents

Related product manuals