Action To display prefix-list outbound route filters received from the specified neighbor:
host1#show ip bgp neighbors 192.168.1.158 received prefix-filter
ip prefix-list filter 192.168.1.158 for address family ipv4:unicast
seq 5 permit 10.1.1.1/32
seq 10 permit 10.1.1.2/32
seq 15 permit 10.1.1.3/32
Meaning Table 38 on page 188 lists the show ip bgp neighbors received prefix-filter command
output fields.
Table 38: show ip bgp neighbors received prefix-filter
Field DescriptionField Name
Sequence number of the entry in the prefix listseq
Condition statement for addresses matching the listed addresspermit, deny
Related Topics show ip bgp neighbors•
Monitoring Routes Originating from a BGP Neighbor Before Application of Inbound
Policy
Purpose Display routes originating from the specified BGP neighbor before inbound policy is
applied. Report whether the indirect next hop of a route is unreachable; if not, display
the IGP cost to the indirect next hop.
The show ip bgp neighbors received-routes and show bgp ipv6 neighbors
received-routes commands display similar information.
Action To display routes originating from the specified BGP neighbor before inbound policy is
applied:
host1#show ip bgp neighbors 192.168.1.158 received-routes
Local BGP identifier 111.111.111.111, local AS 444
0 routes (0 bytes used), 0 distinct destinations (0 bytes used)
0 routes selected for route table installation
0 path attribute entries (0 bytes used)
Status codes: > best, * invalid, s suppressed, d dampened, r rejected
Prefix Peer Next-hop MED LocPrf Weight Origin
>0.0.0.0/0 192.168.1.158 192.168.1.158 0 IGP
>13.13.13.13/32 192.168.1.158 192.168.1.158 0 0 IGP
Meaning Table 39 on page 188 lists the show ip bgp neighbors received-routes command output
fields.
Table 39: show ip bgp neighbors received-routes Output Fields
Field DescriptionField Name
BGP router ID of the local routerLocal BGP identifier
Copyright © 2010, Juniper Networks, Inc.188
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
