Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Table 60: show atm vc Output Fields (continued)
Field DescriptionField Name
Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAMEncap
Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, CBR
Category
Peak rate in KbpsRx/Tx Peak
Average rate in KbpsRx/Tx Avg
Maximum number of cells that can be burst at the peak cell rateRx/Tx Burst
State of the virtual circuit: Up, DownStatus
Starting virtual path identifier (inclusive) of the reserved VC rangeStart VPI
Starting virtual circuit identifier (inclusive) of the reserved VC rangeStart VCI
Ending virtual path identifier (inclusive) of the reserved VC rangeEnd VPI
Ending virtual circuit identifier (inclusive) of the reserved VC rangeEnd VCI
Related Topics show atm vc•
Monitoring Global Call Admission Control Configuration
Purpose Display global call admission control (CAC) configuration.
Action To display CAC configuration:
host1#show cac
resource info flood interval 180
Related Topics show cac•
Monitoring Interfaces Configured with Traffic Engineering Bandwidth Accounting
Purpose Display interfaces on which traffic engineering bandwidth accounting is configured.
Action To display information about CAC interfaces:
host1#show cac interface
atm2/0
bandwidth 10 kbps
IP/MPLS reserveable bw 10 kbps
current total available bw 10 kbps
MPLS TE flooding threshold:
up 15 30 45 60 75 80 85 90 95 96 97 98 99 100
down 100 99 98 97 96 95 90 85 80 75 60 45 30 15
327Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Monitoring MPLS

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English