Juniper JUNOSE 11.2.X BGP AND MPLS

CHAPTER 15
Configuring VPWS
This chapter describes how to configure virtual private wire service (VPWS) L2VPNs on
the router, and contains the following sections:
•
Configuring VPWS on a PE Router on page 651
•
Configuring an VPWS Instance on page 652
•
Configuring BGP Multihoming for VPWS on page 653
•
Types of Interfaces to Configure in the VPWS Instance on page 654
•
Configuring Customer-Facing Interfaces in the VPWS Instance on page 654
•
Local Cross-Connects for VPWS Overview on page 655
•
Configuring a Local Cross-Connect for VPWS on page 655
•
BGP Loopback Interface and Router ID Overview on page 656
•
Configuring the Loopback Interface and Router ID for BGP for VPWS on page 656
•
BGP Signaling for VPWS Overview on page 656
•
Configuring BGP Signaling for VPWS on page 657
•
MPLS LSPs for VPWS Overview on page 658
•
Configuring MPLS LSPs for VPWS on page 658
•
Example: Configuring VPWS on Local and Remote Routers on page 659
Configuring VPWS on a PE Router
To configure a PE router to provide VPWS:
1. Configure an VPWS instance.
See “Configuring BGP Multihoming for VPWS” on page 653 and (optional) “Configuring
an VPWS Instance” on page 652
2. Configure the customer-facing interfaces in the VPWS instance.
See “Configuring Customer-Facing Interfaces in the VPWS Instance” on page 654
3. (Optional) Configure local cross-connects.
See “Configuring a Local Cross-Connect for VPWS” on page 655
4. Configure the loopback interface and router ID for BGP.
651Copyright © 2010, Juniper Networks, Inc.