Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

MPLS shim interface UID is 0x2d000007
Lower interface UID is 0x0b000005
Condensed location is 0x00020000
Received:
3 packets
204 bytes
19 errors
0 discards
Sent:
0 packets
0 bytes
0 errors
0 discards
queue 0: traffic class best-effort, bound to atm-vc ATM2/0.100
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
Meaning Table 141 on page 676 lists the show l2vpn interface command output fields.
Table 141: show l2vpn interface Output Fields
Field DescriptionField Name
Type and specifier for MPLS shim interfaceMPLS shim interface
Type of ATM circuitATM circuit type
Name of the VPWS instance to which the interface belongsMember of L2VPN instance
Local customer site ID configured on the interfaceLocal site ID
Remote customer site ID configured on the interfaceRemote site ID
Local preference for the control word, preferred or not preferredControl word
Local preference for sequence numbers, send or don’t sendsend sequence numbers
Type of signaling and encapsulation used by the router for layer 2
traffic
Relay format
Administrative state of the interface, enabled or disabledAdministrative state
Operational state of the interface, up or downOperational state
Maximum allowable size in bytes of the maximum transmission
unit for the interface
Operational MTU
UID automatically assigned to the MPLS shim interface when it is
created
MPLS shim interface UID
UID automatically assigned to the MPLS major interface when it is
created
Lower interface UID
Copyright © 2010, Juniper Networks, Inc.676
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English