Meaning Table 33 on page 178 lists the show ip bgp flap-statistics command output fields.
Table 33: show ip bgp flap-statistics Output Fields
Field DescriptionField Name
BGP router ID of the local routerLocal BGP identifier
Local autonomous system numberlocal AS
Status of route flap dampening (enabled or disabled)Route flap dampening
Time (in minutes) after which a penalty is decreased. After the route
has been assigned a penalty, the penalty is decreased by half after
the half-life period (which is 15 minutes by default).
Default decay half-life
Value of the penalty for a flapping route below which the route is
unsuppressed
Default cutoff threshold
Time (in hours:minutes:seconds) after which the path will be made
available
Default reuse threshold
Interval, in seconds, after not receiving a keepalive message that
the software declares a peer dead
Default maximum
hold-down time
Status of route flap history for route pathsroute flap history
Prefix for the routing table entryPrefix
IP address of BGP peerPeer
Status of route dampening of the route pathStatus
A measure of the route's stability. Higher values indicate more recent
route flap activity or less stability.
Figure of Merit
Time until the route is either reused (if currently suppressed) or its
history entry is removed (if currently available)
Time until Reuse/Remove
Related Topics show bgp ipv6 flap-statistics•
• show ip bgp flap-statistics
Monitoring BGP Routes with Inconsistent AS Paths
Purpose Display information about routes that have inconsistent AS-paths. Report whether the
indirect next hop of a route is unreachable; if not, display the IGP cost to the indirect next
hop.
The show ip bgp inconsistent-as and show bgp ipv6 inconsistent-as commands display
similar information.
Copyright © 2010, Juniper Networks, Inc.178
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
