EasyManuals Logo
Home>Juniper>Software>JUNOSE 11.2.X BGP AND MPLS

Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Juniper JUNOSE 11.2.X BGP AND MPLS
742 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
Table 25: show ip bgp Output Fields (continued)
Field DescriptionField Name
Community number associated with the routeCommunities
Routes that have gone stale due to peer restartStale
Number of unicast routes in the BGP routing table that have been
inserted into the IP routing table that are also available for use in
the multicast view of the IP routing table
unicast/multicast routes
selected for route table
installation
Number of unicast and multicast routes in the BGP routing table
that have been inserted into the IP routing table that are also
available for use in the IP tunnel routing table
unicast/multicast
tunnel-usable routes
selected for route table
installation
Number of routes in the BGP routing table that have been inserted
into the IP tunnel routing table
tunnel-only routes selected
for tunnel-route table
installation
Number of distinct path attributes stored in BGP's internal path
attributes table. If BGP receives two routes for different prefixes
but with identical path attributes, BGP will create only one entry in
its internal path attribute table and share it between the two routes
to conserve memory.
path attribute entries
Timestamp indicating when the statistics baseline was last setStatistics baseline set
Indicates whether network-route filtering is enabledRoute-map
Indicates whether an IGP backdoor route is favored over an EBGP
route
Backdoor
Calculated preferenceCalPrf
Related Topics show bgp ipv6•
• show ip bgp
Monitoring Advertised BGP Routes
Purpose Display the routes in the specified neighbor’s or peer group’s Adj-RIBs-Out table for IPv4
or IPv6.
For peers, display the attributes associated with the route before the application of any
outbound policy. For peer groups, display the attributes associated with the route after
the application of any outbound policy; that is, the actual advertised attributes. Report
whether the indirect next hop of a route is unreachable; if not, display the IGP cost to the
indirect next hop.
167Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Monitoring BGP

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper JUNOSE 11.2.X BGP AND MPLS and is the answer not in the manual?

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General IconGeneral
BrandJuniper
ModelJUNOSE 11.2.X BGP AND MPLS
CategorySoftware
LanguageEnglish

Related product manuals