Table 96: show ip protocols Output Fields (continued)
Field DescriptionField Name
Access list applied to incoming RIP route updatesFilter applied to incoming
route update
Route map that specifies all RIP interfaces on the routerGlobal route map
Value added to RIP routes added to the IP routing table. The default
is 120.
Distance
Interface type on which RIP protocol is runningInterface
Protocol to which RIP is redistributing routesRedistributing
Network for which RIP is currently injecting routesRouting for Networks
Related Topics show ip protocols•
Monitoring the VRF Routing Table
Purpose Display the routing table of the specified VRF
Action To display the routing table of the VRF
host1#show ip route vrf vpn2
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
Prefix/Length Type Next Hop Dist/Met Intf
--------------- ------- ---------- -------- ------------
45.5.5.5/32 Connect 45.5.5.5 0/1 fastEthernet3/0
56.5.5.0/24 Connect 56.5.5.5 0/1 atm4/0.21
Meaning Table 97 on page 496 lists the show ip route command output fields.
Table 97: show ip route Output Fields
Field DescriptionField Name
Type of routeProtocol/Route type codes
Network prefix for route in VRF routing tablePrefix/Length
Protocol of routeType
IP address of the next hop to reach routeNext Hop
Administrative distance and metric applied to routeDist/Met
Copyright © 2010, Juniper Networks, Inc.496
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
