Juniper JUNOSE 11.2.X BGP AND MPLS

Clearing BGP Attributes for VPLS
You can use the following clear ip bgp commands to remove specific BGP attributes for
the L2VPN address family, and in one case, for the VPLS address family associated with
a specific VPLS instance.
•
Clearing BGP Reachability Information for the L2VPN Address Family on page 612
•
Clearing BGP Route Flap Dampening Information for the L2VPN Address
Family on page 612
•
Clearing BGP Route Flap Dampening Information for the VPWS Address
Family on page 612
•
Clearing the Wait for End-of-RIB Marker for the L2VPN Address Family on page 612
Clearing BGP Reachability Information for the L2VPN Address Family
To clear BGP reachability information for the L2VPN address family:
•
Issue the clear ip bgp command.
host1#clear ip bgp l2vpn soft in
Use the soft in keywords to trigger inbound soft reconfiguration.
Clearing BGP Route Flap Dampening Information for the L2VPN Address Family
To clear route flap dampening information for the L2VPN address family:
•
Issue the clear ip bgp dampening command.
host1#clear ip bgp l2vpn dampening
Clearing BGP Route Flap Dampening Information for the VPWS Address Family
To clear route flap dampening information for the VPLS address family associated with
the specified VPLS instance:
•
Issue the clear ip bgp dampening command.
host1#clear ip bgp vpls vplsA dampening
Clearing the Wait for End-of-RIB Marker for the L2VPN Address Family
To clear the wait for receiving an End-of-RIB marker from the peer for the L2VPN address
family:
•
Issue the clear ip bgp wait-end-of-rib command.
host1#clear ip bgp l2vpn wait-end-of-rib
Related Topics clear ip bgp•
• clear ip bgp dampening
• clear ip bgp wait-end-of-rib
Copyright © 2010, Juniper Networks, Inc.612
JunosE 11.2.x BGP and MPLS Configuration Guide