CHAPTER 4
Configuring MPLS
This chapter describes how to configure Multiprotocol Label Switching (MPLS) on the
router, and contains the following sections:
•
Basic MPLS Configuration Tasks on page 276
•
MPLS Global Configuration Tasks on page 277
•
LDP and RSVP-TE Interface Profile Configuration Tasks on page 280
•
MPLS Interface Configuration Tasks on page 281
•
MPLS Tunnel Configuration Tasks on page 283
•
MPLS Tunnel Profile Configuration Tasks on page 285
•
Configuring Explicit Routing for MPLS on page 286
•
Additional LDP Configuration Tasks on page 288
•
Configuring LDP FEC Deaggregation on page 288
•
Configuring LDP Graceful Restart on page 289
•
Configuring LDP Autoconfiguration on page 290
•
Configuring LDP-IGP Synchronization on page 291
•
Configuring LDP MD5 Authentication on page 291
•
Controlling LDP Label Distribution on page 292
•
Additional RSVP-TE Configuration Tasks on page 293
•
Configuring RSVP MD5 Authentication on page 294
•
Configuring RSVP-TE Fast Rerouting with RSVP-TE Bypass Tunnels on page 295
•
Configuring RSVP-TE Hello Messages to Determine Peer Reachability on page 297
•
Configuring RSVP-TE Graceful Restart on page 298
•
Configuring RSVP-TE Hellos Based on Node IDs on page 299
•
Configuring the BFD Protocol for RSVP-TE on page 300
•
Configuring IGPs and MPLS on page 301
•
Configuring MPLS and Differentiated Services on page 303
•
Configuring the Tunneling Model for Differentiated Services on page 304
•
Configuring EXP Bits for Differentiated Services on page 304
•
Example Differentiated Services Application and Configuration on page 305
275Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...