For point-to-point interfaces, this command displays a single secure association with
the single peer at the remote end. For multiaccess type interfaces (Ethernet), this
command displays, if present, multiple secure associations from the various RSVP
speakers.
Action To display information about RSVP-TE major interfaces on which BFD is enabled:
host1#show mpls rsvp bfd interfaces
Bfd Enabled RSVP interfaces
---------------------------
Minimum Minimum Minimum
Interface Interval Rx-Interval Tx-Interval Multiplier
--------- -------- ----------- ----------- ----------
ATM2/0.1 300 300 300 3
Meaning Table 83 on page 363 lists the show mpls rsvp bfd interfaces command output fields.
Table 83: show mpls rsvp bfd interfaces Output Fields
Field DescriptionField Name
RSVP-TE major interface on which BFD is enabledInterface
Minimum interval in milliseconds, used when the minimum receive
interval and minimum transmit intervals have the same value
Minimum Interval
Minimum receive interval in milliseconds; minimum interval at which
the local peer must receive BFD control packets from the remote
peer
Minimum Rx-Interval
Minimum transmit interval in milliseconds; interval at which the
local peer proposes to transmit BFD control packets to the remote
peer
Minimum Tx-Interval
Detection multiplier value; roughly equivalent to the number of
packets that can be missed before the BFD session is declared to
be down
Multiplier
Related Topics show mpls rsvp bfd interfaces•
Monitoring RSVP-TE Interface Counters
Purpose Display various counters for a particular RSVP-TE interface or all RSVP-TE interfaces.
Action To display counters for RSVP-TE interface atm 6/0.1:
host1#show mpls rsvp counters atm 6/0.1
Interface ATM6/0.1
Path Sent 247 Path Rcvd 0
Path Error Sent 0 Path Error Rcvd 0
Path Tear Sent 0 Path Tear Rcvd 0
Resv Sent 0 Resv Rcvd 245
Resv Error Sent 0 Resv Error Rcvd 0
Resv Tear Sent 0 Resv Tear Rcvd 0
363Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Monitoring MPLS
To Next Page
Loading...
Need help?
General
