•
Issue the baseline mpls interface command:
host1#baseline mpls interface
Related Topics baseline mpls interface•
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
Purpose Display the current systemwide values configured on the router for the three ATM Martini
cell packing timers.
The ATM Martini cell packing timers define the time threshold that the router uses to
collect and concatenate ATM cells in a single VCC cell relay–encapsulated packet.
Action To display ATM Martini cell packing timers:
host1(config)#show atm mcpt-timers
ATM Martini cell aggregation timers:
Timer1: 1500microseconds
Timer2: 2500microseconds
Timer3: 3500microseconds
Meaning Table 103 on page 562 lists the show atm mcpt-timers command output fields
Table 103: show atm mcpt-timers Output Fields
Field DescriptionField Name
Value in microseconds for the first ATM Martini cell packing timerTimer1
Value in microseconds for the second ATM Martini cell packing timerTimer2
Value in microseconds for the third ATM Martini cell packing timerTimer3
Related Topics show atm mcpt-timers•
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS
Purpose Display the current state of all specified ATM subinterfaces.
Action To display the current state of all ATM subinterfaces:
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type Encap MTU Status Address
----------- -------- --- --- --- ---- ----- ---- ------ -------
ATM 2/0.100 ATM/MPLS 100 0 100 PVC AAL0 9180 up --
ATM 2/0.101 ATM/MPLS 101 0 101 PVC AAL5 9180 up --
ATM 2/0.200 RFC-1483 200 0 200 PVC SNAP 9180 up --
ATM 2/0.201 RFC-1483 201 0 201 PVC SNAP 9180 up --
4 interface(s) found
To display the current state of a specific ATM subinterface:
host1#show atm subinterface atm 2/0.100
Circuit Interface
Copyright © 2010, Juniper Networks, Inc.562
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
