Multicast Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
To display brief information about the interfaces associated with the VRFs:
host1#show ip interface vrf vpn1 brief
Interface IP-Address Status Protocol Description
null0 255.255.255.255 up up
atm4/0.77 7.8.7.7 up up
Meaning Table 95 on page 492 lists the show ip interface vrf command output fields.
Table 95: show ip interface vrf Output Fields
Field DescriptionField Name
Type of network protocol configuredNetwork Protocols
IP address of the subnetBroadcast address
Interface type and interface specifierinterface
Status of the interfaceinterface status
Status of the protocolProtocol Description
Status of the line protocolline protocol
Status of SNMP link up/down traps on the interfaceLink up/down trap
IP address of the interfaceInternet address
Actual MTU for the interfaceOperational MTU
Configured MTU for the interfaceAdministrative MTU
Actual speedOperational speed
Configured speedAdministrative speed
Value of sysUpTime the last time the integrity of the interface
statistics was compromised
Discontinuity Time
Whether routes are advertised; enabled or disabledRouter advertisement
Configured debounce behavior, enabled or disabled.
• Enabled—Indicates time in milliseconds that the router waits
before generating an up or down event in response to a state
change in the interface.
• If the state changes back before the debounce timer expires, no
state change is reported.
Administrative
debounce-time
Copyright © 2010, Juniper Networks, Inc.492
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
