Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Monitoring VRF Routing Protocols
Purpose Display information about the routing protocols associated with the VRF
Action To display information about OSPF routing protocol associated with the VRF
host1:pe1#show ip protocols vrf pe13
Routing Protocol is “ ospf 1" with Router ID 13.13.13.1
Distance is 110
Redistributing: bgp
Address Summarization:
None
Routing for Networks:
13.13.13.0/255.255.255.0 area 0.0.0.0
Meaning Table 96 on page 494 lists the show ip protocols command output fields.
Table 96: show ip protocols Output Fields
Field DescriptionField Name
Protocol configured for routingRouting Protocol
BGP
Protocol to which BGP is redistributing routesRedistributing
Local preference valueDefault local preference
Status of IGP synchronization: enabled, disabledIGP synchronization
Status of multiexit discrimination: enabled, disabledAlways compare MED
Status of route dampening: enabled, disabledRouter flap damping
External, internal, and local administrative distancesAdministrative Distance
IP address of the BGP neighborNeighbor Address
Number of the access list for outgoing routesNeighbor
Incoming/Outgoing update
distribute list
Number of the prefix list for incoming or outgoing routesNeighbor
Incoming/Outgoing update
prefix list
Number of the prefix tree for incoming or outgoing routesNeighbor
Incoming/Outgoing update
prefix tree
Number of filter list for incoming routesNeighbor
Incoming/Outgoing update
filter list
Copyright © 2010, Juniper Networks, Inc.494
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English