Meaning Table 29 on page 172 lists the show ip bgp community command output fields.
Table 29: show ip bgp community Output Fields
Field DescriptionField Name
BGP router ID of the local routerLocal router ID
Local autonomous system numberlocal AS
Total number of routes stored in the BGP routing table and amount
of memory consumed by routes. If several peers have advertised a
route to the same prefix, all routes are included in this count.
routes
Total number of routes stored in the BGP routing table. If several
peers have advertised a route to the same prefix, all routes are
included in this count.
paths
Number of routes to unique prefixes stored in the BGP routing table.
If several peers have advertised a route to the same prefix, only the
best route is included in this count.
distinct prefixes
Number of routes in the BGP routing table that have been inserted
into the IP routing table
routes selected for route
table installation
Number of distinct path attributes stored in BGP's internal path
attributes table. If BGP receives two routes for different prefixes
but with identical path attributes, BGP will create only one entry in
its internal path attribute table and share it between the two routes
to conserve memory.
path attribute entries
Prefix for the routing table entryPrefix
IP address of BGP peerPeer
IP address of the next hopNext hop IP address
Multiexit discriminator for the routeMED
Calculated preference for the routeCalPrf
Assigned path weightWeight
Origin of the routeOrigin
Related Topics show bgp ipv6 community•
• show ip bgp community
Copyright © 2010, Juniper Networks, Inc.172
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
