Juniper JUNOSE 11.2.X BGP AND MPLS

Action To display ATM cross-connects:
host1#show mpls cross-connects atm
Cate Peak
VC-ID Encap gory Rate Interface VPI VCI Status
------ ----- ---- ---- ---------- --- --- ------
600001 AAL5 UBR 0 ATM6/0.101 0 101 Up
ATM6/2.101 0 101 Up
600002 AAL5 UBR 0 ATM6/0.102 0 102 Up
ATM6/2.102 0 102 Up
2 local connection(s) found
Meaning Table 105 on page 564 lists the show mpls cross-connects atm command output fields
Table 105: show mpls cross-connects atm Output Fields
Field DescriptionField Name
VC ID number of the connectionVC-ID
Administered encapsulation method based on what was configured
with the atm pvc command
Encap
Configured service categoryCategory
Send and receive peak rate, in KbpsPeak Rate
Specifier and status of the first subinterface that makes up the local
cross-connect
Interface
Virtual path identifier of the first subinterfaceVPI
Virtual channel identifier of the first subinterfaceVCI
Current state of the connectionStatus
Related Topics show mpls cross-connects atm•
Monitoring MPLS Forwarding for Layer 2 Services over MPLS
Purpose Display configuration and statistics for all label-switched paths (LSPs) or for specific
LSPs configured on the label-switching router (LSR). The brief keyword displays only
the the action taken for each in label.
Action To display LSP configuration and statistics from the MPLS forwarding table:
host1:two#show mpls forwarding
serial4/1:1/1/1/1/1.1 to 222.9.1.3
In label 20
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Out label 45 on tun mpls:1 nbr 222.9.1.3
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Copyright © 2010, Juniper Networks, Inc.564
JunosE 11.2.x BGP and MPLS Configuration Guide