host1#show ldp interface
Interface ATM6/0.120
Interface address: 192.168.12.1/28
Enabled with profile 'default'
Configured hold time: 15
Hello interval: 5
Hold Time: 1
242 hello received, 242 hello sent, 0 hello rejected
1 adjacency created, 0 adjacency deleted,
Number of adjacencies = 1
Link hello adjacency: Address: 10.10.12.2, Transport address: 80.0.2.2,
Up for 00:20:09, Remaining hold time: 11 sec
To display brief information about LDP interfaces:
host1#show ldp interface brief
Interface IP-Address Protocol
ATM6/1.1 192.168.100.21/30 enabled
ATM6/1.3 192.168.100.17/30 enabled
ATM6/1.5 192.168.100.13/30 enabled
ATM6/0.7 172.16.100.1/30 enabled
ATM6/0.8 172.16.100.22/30 enabled
ATM6/0.9 172.16.100.14/30 enabled
NOTE: The mpls keyword is optional and is provided for compatibility with non–E Series
implementations.
Meaning Table 67 on page 335 lists the show ldp interface command output fields.
Table 67: show ldp interface Output Fields
Field DescriptionField Name
Identifier of the interfaceInterface
LDP has been autoconfigured on the interfaceautoconfigured
IP address of the interface, with address maskInterface address
Name of profile with which interface was enabledEnabled with profile
Configured period for which a sending LSR maintains a record of
link hello messages from the receiving LSR without receipt of
another link hello message from that LSR, in seconds
Configured hold time
Negotiated interval between link-hello packets, in secondsHello interval
Lowest configured hold time among all neighbors on the same
subnet, used as the effective hold time, in seconds
Hold time
Number of LDP adjacencies for the interfaceNumber of adjacencies
335Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Monitoring MPLS
To Next Page
Loading...
Need help?
General
