Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Action To display information for the VPLS virtual core interface:
host1#show bridge interface vpls vplsB
vpls vplsB
BridgeGroup: vplsB
Port Number: 2
Operational Status: Up
Admin Status: Up
Snmp Link Status Trap: Disabled
Max Learn: Unlimited
Subscriber Policy: default Trunk
Statistics:
In Octets: 0
In Frames: 0
In Discards: 0
In Errors: 0
Out Octets: 0
Out Frames: 0
Out Discards: 0
Out Errors: 0
Time since counters last reset: 00:12:53
Meaning Table 122 on page 620 lists the show bridge interface vpls command output fields.
Table 122: show bridge interface vpls Output Fields
Field DescriptionField Name
Name of the VPLS instance to which the interface belongsBridgeGroup
Port number on which this interface residesPort Number
Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Operational Status
State of the physical interface: Up, DownAdmin Status
Whether SNMP link status processing is enabled or disabled for the
specified interface
Snmp Link Status Trap
Maximum number of dynamic MAC addresses that the interface
can learn
Max Learn
Name of the subscriber policy currently in effect for the interfaceSubscriber Policy
Displays statistics information for the specified portStatistics
Number of octets received on this interfaceIn Octets
Number of frames received on this interfaceIn Frames
Number of incoming packets discarded on this interfaceIn Discards
Number of incoming errors received on this interfaceIn Errors
Copyright © 2010, Juniper Networks, Inc.620
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English