MPLS next-hop: 34, ECMP next-hop, leg count 2
MPLS next-hop: 17, resolved by MPLS next-hop 16, peer 2.2.2.2
MPLS next-hop: 16, primary(in use): label 26 on ATM5/0.10, secondary: resolved by MPLS next-hop 0
Meaning Table 62 on page 330 lists the show ip tunnel-route command and show ipv6 tunnel
route command output fields.
Table 62: show ip tunnel route and show ipv6 tunnel-route Output Fields
Field DescriptionField Name
IPv4 or IPv6 address prefix of network destinationPrefix
Network mask length for prefixLength
Type of route; protocolType
IP address of the next hop to the route, whether it is a local interface
or another router; not displayed for IPv6 tunnel routing table
Next Hop
Administrative distance for the routeDst or Distance
Number of hops; metricMet or Metric
Interface type and interface specifierInterface
Numeric tag that identifies routeTag
Attribute of a route applied only as a result of set route-class clause
in a table map
Class
Related Topics show ip tunnel-route•
• show ipv6 tunnel-route
Monitoring LDP
Purpose Display information about LDP.
Action To display LDP information:
host1#show ldp
LDP
LSR ID is 80.0.0.2
FEC Deaggregation is off
Egress label: implicit-null
Label distribution control mode: ordered control
LDP session retry 0 times at interval 10
LDP session hold time: 180
LDP session keepalive interval: 20
LDP targeted-hello hold time: 45
LDP targeted-hello interval: 15
Topology Driven LSP enabled
Copyright © 2010, Juniper Networks, Inc.330
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
