Juniper JUNOSE 11.2.X BGP AND MPLS

Table 70: show ldp statistics Output Fields (continued)
Field DescriptionField Name
Number of no address eventsNo address
Number of no interface eventsNo interface
Number of no session eventsNo session
Number of no adjacency eventsNo adjacency
Number of unknown version eventsUnknown version
Number of malformed PDU eventsMalformed PDU
Number of malformed message eventsMalformed message
Number of unknown message type eventsUnknown message type
Number of inappropriate message eventsInappropriate message
Number of inappropriate message eventsMalformed tlv
Number of bad TLV value eventsBad TLV value
Number of missing TLV eventsMissing TLV
Number of PDU too large eventsPDU too large
Number of PDU too small eventsPDU too small
Number of no memory eventsNo Memory
Related Topics show ldp statistics•
Monitoring LDP Targeted Hello Receive and Send Lists
Purpose Display LDP targeted hello receive or send list, or both.
Action To display both the LDP targeted hello receive and send lists:
host1#show ldp targeted session
Mpls Target Session Status:
D = Dynamically, S = Statically, A = Access List Configured
Targeted session sent to 10.9.1.3 is up Used By: D
indirect nexthop index 3, resolved
Targeted session sent to 10.9.1.6 is up Used By: S
indirect nexthop index 206, resolved
Meaning Table 71 on page 343 lists the show ldp targeted session command output fields.
Copyright © 2010, Juniper Networks, Inc.342
JunosE 11.2.x BGP and MPLS Configuration Guide