Lower Oper
Interface MplsMajor state Direction
---------------- --------- ----- ---------
pe1-to-pe2 ATM2/0.10 up transmit
lsp-02020202-1-4 ATM2/0.10 up receive
ERX-01-0c-d7:pe1#
Meaning Table 76 on page 352 lists the show mpls interface command output fields.
Table 76: show mpls interface Output Fields
Field DescriptionField Name
Specifier and status of each interfaceInterface
Status of RSVP, configured or not, and profile usedRSVP
Status of LDP, configured or not configured, and profile usedLDP
IP address of IP interfaces and session statusIP interfaces on this MPLS
interface
Internal, platform-dependent, 32-bit representation of the interface
location, used by Juniper Networks Customer support for
troubleshooting.
Condensed location
Number of labels allocated and advertised to this peerlabel alloc
Number of labels received from this peerlabel learned
Cumulative total number of labels allocated and advertised to this
peer
accum label alloc
Cumulative total number of labels received from this peeraccum label learned
Number of notification messages received or received bad or sentnotf
Number of label mapping messages received or received bad or
sent
mapping
Number of messages sent or receivedmsg
Number of label request messages received or received bad or sentrequest
Number of label request abort messages for downstream on
demand received or received bad or sent
abort
Number of label release messages received or received bad or sentrelease
Number of label withdraw messages received or received bad or
sent
withdraw
Number of address messages received or received bad or sentaddr
Copyright © 2010, Juniper Networks, Inc.352
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
