Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Figure 105: Static Route to Shared IP Interface
The following commands configure the shared interface and a static route:
host1(config)#virtual-router pe1
host1:pe1(config)#interface ip ce1-cust
host1:pe1(config-if)#ip share-interface atm2/0.1
host1:pe1(config-if)# ip address 10.1.1.3 255.255.255.0
host1:pe1(config-if)#exit
host1:pe1(config)#ip route 10.4.4.4 255.255.255.255 ip ce1-cust
Global Export Map
The global export map enables VPN routes to be automatically exported from the BGP
RIB table in a VRF to the global BGP RIB table (the BGP RIB table of the parent VR) based
on policy. A route map determines which routes are exported and which are not.
When they are installed in the global IP routing table, these exported routes point to the
IP interface in the VRF as shown in Figure 106 on page 469. See “Global Export Maps” on
page 432 for more information.
Copyright © 2010, Juniper Networks, Inc.468
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English