Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Table 35: show ip bgp neighbors Output Fields (continued)
Field DescriptionField Name
IP address used when sending update messagesConfigured update source
IP address
Local IP address used for TCP communication to this peerLocal IP address
Local TCP port number used for TCP communication to this peerLocal port
Remote IP address used for TCP communication to this peerRemote IP address
Remote IP address used for TCP communication to this peerRemote port
Total BGP messages sent to this neighborTotal messages sent
Total BGP messages received from this neighborTotal messages received
Total BGP update messages sent to this neighborTotal update messages
sent
Total BGP update messages received from this neighborTotal update messages
received
Time since last BGP update message was received from this
neighbor
Time since last update
message was received
Lists type of ORF send and receive capability per address family
and whether it is advertised (configured) or received
Address Family dependent
capabilities
Limit of ORF entries that will be accepted from the neighborMaximum number of ORF
entries
Lists whether the specific capability (capabilities option, deprecated
dynamic capability negotiation, dynamic capability negotiation,
multiprotocol extensions, route refresh, route refresh (Cisco
proprietary), four octet AS numbers, and graceful restart) has been
sent, received, or both
Capability advertisement
Lists the relevant address family and whether it has been sent,
received, or used
Multi-protocol extensions
negotiation
Status of BFD configuration, enabled, enabled but not supported
because the peer is an IBGP neighbor a multihop EBGP neighbor,
or disabled
BFD
Type and address of peer to which BFD session is establishedBFD session
Desired interval between BFD packets transmitted to members of
peer group
Minimum transmit interval
Desired interval between BFD packets received from members of
peer group
Minimum receive interval
Copyright © 2010, Juniper Networks, Inc.184
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English