Table 44: show ip bgp peer-group Output Fields (continued)
Field DescriptionField Name
Status of BFD configuration for the peer group (enabled or disabled)BFD
Type and address of peer to which BFD session is establishedBFD session
Textual description of the BGP neighborDescription
Name of the peer group of which this BGP neighbor is a memberMembers
IP addresses of the members of the BGP peer groupDefault originate
Desired time interval between BFD packets transmitted to members
of peer group
Minimum transmit interval
Desired time interval between BFD packets received from members
of peer group
Minimum receive interval
Number of BFD packets that can be missed before declaring BFD
session down
Multiplier
Status of next-hop self information for the peer group (enabled or
disabled)
Next hop self
BGP peer group is configured as a route reflector. This field does
not appear when route reflectors are not configured.
Peers are route reflector
clients
Neighbor weights assigned to BGP peer groupsweight
Distribute list for incoming routes, if configuredIncoming update distribute
list
Distribute list for outgoing routes, if configuredOutgoing update distribute
list
Update filter list for incoming routes, if configuredIncoming update filter list
Update filter list for outgoing route, if configuredOutgoing update filter list
Weight filter list for routes, if configuredWeight filter list
Incoming route map, if configuredIncoming route map
Outgoing route map, if configuredOutgoing route map
Minimum time between route advertisementsMinimum route
advertisement interval
IP address used when sending update messagesConfigured update source
IP address
195Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Monitoring BGP
To Next Page
Loading...
Need help?
General
