Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Table 47: show bgp ipv6 summary Output Fields (continued)
Field DescriptionField Name
Status of auto summarization of routes redistributed into BGPAuto-summary
Status, enabled or disabledAlways compare MED
Status, enabled or disabledCompare MED within
confederation
Status, enabled or disabledAdvertise inactive routes
Status, enabled or disabledAdvertise best external
route to internal peer
Status, enabled or disabledEnforce first AS
Status, enabled or disabledMissing MED as worst
Status, enabled or disabledRoute flap dampening
Number of pathsMaximum number of
equal-cost EBGP paths
Number of pathsMaximum number of
equal-cost IBGP paths
Status, enabled or disabledLog neighbor changes
Status, enabled or disabledFast External Fallover
Indicates whether limit is set for AS path length and, if set, the limitNo maximum received
AS-path length
Distances for external, internal, and local BGP routesBGP administrative
distances
Indicates whether the router has been configured as a route reflectorRouter is a route reflector
Whether client-to-client reflection is configured (enabled) or not
(disabled)
Client-to-client reflection
Identifying number for cluster IDCluster ID
Status, enabled or disabledRoute-target filter
Status, enabled or disabledDefault IPv4-unicast
Status, enabled or disabledRedistribution of iBGP
routes
Copyright © 2010, Juniper Networks, Inc.202
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English