Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

host2(config)#exit
host2(config)#interface atm 4/0.101
host2(config-subif)#atm pvc 101 0 101 aal0
host2(config-subif)#atm cell-packing 150 mcpt-timer 3
host2(config-subif)#mpls-relay 5.1.1.1 1
host2(config-subif)#exit
7. (Optional) Use the appropriate show commands to verify your configuration.
host1#show atm mcpt-timers
ATM Martini cell aggregation timers:
Timer1: 1500microseconds
Timer2: 2500microseconds
Timer3: 3500microseconds
host1#show atm subinterface atm 2/0.100
Circuit Interface
Interface ATM-Prot VCD VPI VCI Type Encap MTU Status Type
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 2/0.100 ATM/MPLS 100 0 100 PVC AAL0 9180 lowerLayerDown Static
Maximum number of cells per packet: 100
Cell aggregation timeout timer: 2
SNMP trap link-status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InPacketsUnknownProtocol: 0
OutDiscards: 0
1 interface(s) found
host2#show atm subinterface atm 4/0.101
Circuit Interface
Interface ATM-Prot VCD VPI VCI Type Encap MTU Status Type
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 4/0.101 ATM/MPLS 101 0 101 PVC AAL0 9180 lowerLayerDown Static
Maximum number of cells per packet: 150
Cell aggregation timeout timer: 3
SNMP trap link-status: disabled
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
InPacketsUnknownProtocol: 0
OutDiscards: 0
1 interface(s) found
Related Topics atm cell-packing•
537Copyright © 2010, Juniper Networks, Inc.
Chapter 9: Configuring Layer 2 Services over MPLS

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English