Table 131: show vpls connections Output Fields (continued)
Field DescriptionField Name
Index number of the MPLS next hop to which the router floods
packets with unknown destination addresses. For more information
about displaying MPLS next hops and any available next-hop
statistics, see “Monitoring MPLS Next Hops” on page 355.
Flood Next Hop
Type and specifier of the network interfaces and VPLS virtual core
interface associated with the VPLS instance; vpls vplsName in this
field identifies the VPLS virtual core interface
Interface
Port number of the module on which the network interface or VPLS
virtual core interface resides
Port
Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Status
Possible status codes for the VPLS connection that appear in the
State field
Connections status code
Remote site identifierSite
Status of the connection with the remote VPLS instance; possible
values for this field appear in the Connections status code legend
in the command display
State
IP address of the remote VPLS edge (VE) router, which is analogous
to the remote provider edge (PE) router in a BGP/MPLS VPN
configuration
Remote PE
Incoming MPLS label from the remote siteIn-label
Outgoing MPLS label used to reach the remote siteOut-label
MPLS next-hop index number that corresponds to the outgoing
MPLS label
MPLS NH Idx
Time since the last state change for this VPLS connectionUp-down Time
Related Topics • show vpls connections
635Copyright © 2010, Juniper Networks, Inc.
Chapter 13: Monitoring VPLS
To Next Page
Loading...
Need help?
General
