Juniper JUNOSE 11.2.X BGP AND MPLS - Page 725

documentation set
comments on...............................................................xxxv
domain, VPLS........................................................................574
domain-id command.........................................................486
domain-tag command......................................................486
dont-install-routes command.......................................484
DS-BGP routers.....................................................................476
dual-stack BGP routers......................................................476
dynamic capability negotiation.......................................123
dynamic interfaces, created by MPLS..........................229
dynamic peering, BGP...........................................................43
dynamic peers, remove BGP..............................................43
dynamic route redistribution, disabling in BGP...........54
dynamically learned defaults.............................................55
E
E-LSP................................................................................212, 307
EBGP (external Border Gateway Protocol)
updates in indirectly connected networks............32
Echo Jitter TLV
contained in echo responses
no action taken....................................................248
detecting data plane failures
at egress nodes in point-to-multipoint
MPLS LSPs.......................................................246
functions of
beneficial when the entire LSP tree is
pinged.................................................................248
preventing flooding of responses.................248
segregating echo responses from multiple
egress nodes....................................................248
invalid in echo responses.........................................248
not contained in echo requests
no delay in echo responses............................248
preconfigured value, default...................................248
supported delay period
exceeded, alternative action taken..............247
maximum value..................................................248
of up to 30 seconds...........................................247
to process MPLS LSP ping messages
delaying the sending of echo
responses...........................................................247
type value defined in
IETF draft, Detecting Data Plane Failures
in Point-to-Multipoint Multiprotocol
Label Switching (MPLS) - Extensions to
LSP Ping ............................................................247
type value, 12.................................................................248
used in MPLS echo request packets
delay the sending of echo responses..........247
uses
preventing echo responses from being
discarded...........................................................248
preventing flooding of responses at ingress
nodes..................................................................248
echo reply packets, MPLS.................................................244
echo request packets, MPLS...........................................244
ECMP (equal-cost multipath)
BGP...................................................................................439
BGP/MPLS VPNs..............................................384, 439
MPLS indirect next hops..........................................384
path failures in BGP/MPLS VPNs..........................384
pruning failed paths...................................................384
Egress Address P2MP Responder Identifier
sub-TLVs
specifying
IPv4 address of egress nodes........................250
IPv6 address of egress nodes........................250
used to denote
a specific egress node from which path
must be traced................................................250
enable a protocol
BGP routing.............................................................18, 439
enable protocols
BGP routing...................................................................656
encapsulations
ATM AAL0.......................................................................518
ATM AAL05....................................................................516
equal-cost multipath support on MPLS......................242
Ethernet aggregation and Martini layer 2
transport.............................................................................539
Ethernet raw mode encapsulation
overview..........................................................................522
Ethernet/VLAN over MPLS (Multiprotocol Label
Switching)
configuration steps.....................................................533
overview.........................................................................509
exit-address-family
command.......................................46, 152, 444, 596, 657
explicit null label, advertise the......................................220
export map
setting the BGP/MPLS VPN....................................428
use......................................................................................431
export map command........................................................431
extended communities
BGP...............................................................................12, 95
route target....................................................................389
689Copyright © 2010, Juniper Networks, Inc.
Index