Juniper JUNOSE 11.2.X BGP AND MPLS - Page 732

inclusion of sub-TLVs of P2MP Responder
Identifier TLV in
IPv4 Egress Address P2MP Responder
Identifier.............................................................249
IPv4 Node Address P2MP Responder
Identifier.............................................................249
IPv6 Egress Address P2MP Responder
Identifier.............................................................249
IPv6 Node Address P2MP Responder
Identifier.............................................................249
sent to nodes other than egress nodes in MPLS
LSPs
echo response to originator............................247
specifying
a delay for echo responses.............................248
without P2MP Responder Identifier TLV
contained
echo response to originator............................247
MPLS echo responses
containing Echo Jitter TLV
no action performed in connectivity
verification........................................................248
controlled by Response Type filed in
requests......................................................................250
delaying sending of
preventing discarding, owing to rate
limiting...............................................................248
preventing flooding at originator..................248
dependence on position of node
in point-to-multipoint LSPs...........................250
sent from a particular egress node
specified in the P2MP Responder Identifier
TLV ......................................................................249
sent from all nodes in the path to ingress
with P2MP Responder Identifier TLV
excluded in requests.....................................249
MPLS L2VPN over LAG
configuration example..............................................550
MPLS L2VPN over VLAN over LAG
configuration example..............................................546
MPLS L2VPNs
over LAG, configuration example..........................550
over VLAN over LAG, configuration
example......................................................................546
MPLS L2VPNs over LAG
on CE-side, overview...................................................521
mpls ldp commands
mpls ldp............................................278, 282, 596, 658
mpls ldp advertise-labels.........................................278
mpls ldp autoconfig..........................................290, 291
mpls ldp deaggregate...............................................289
mpls ldp disable...........................................................282
mpls ldp egress-label................................................278
mpls ldp graceful-restart.........................................289
mpls ldp graceful-restart
reconnect-time........................................................289
mpls ldp graceful-restart recovery-time............289
mpls ldp graceful-restart timers
max-recovery...........................................................289
mpls ldp graceful-restart timers
neighbor-liveness...................................................289
mpls ldp igp sync holddown....................................291
mpls ldp independent-control...............................278
mpls ldp ip-forwarding..............................................278
mpls ldp link-hello disable.......................................282
mpls ldp neighbor password....................................291
mpls ldp profile...................................................278, 282
mpls ldp redistribute..................................................278
mpls ldp session holdtime.......................................278
mpls ldp session keepalive-interval.....................278
mpls ldp session retries.............................................278
mpls ldp session retry-time.....................................278
mpls ldp strict-security..............................................291
mpls ldp sync.................................................................291
mpls ldp targeted-hello holdtime.........................278
mpls ldp targeted-hello interval............................278
mpls ldp targeted-hello receive list......................278
mpls ldp targeted-hello send list..........................278
mpls ldp vpls commands
mpls ldp vpls neighbor.............................................604
mpls ldp vpls vpls-id.................................................604
MPLS LSPs
troubleshooting MTU problems in
with a Martini circuit..........................................379
with a VPLS instance........................................379
with an IP or IPv6 address...............................379
with an L3VPN or IPv6 address.....................379
with an RSVP-TE tunnel..................................379
MPLS Martini circuits
adding on an ATM port
restriction for transmission of multiple ATM
VCs.......................................................................526
transmission of multiple ATM virtual circuits
between two ATM ports..................................526
over a single pseudowire.................................526
using the RSVP configuration
on the same ATM port......................................526
Copyright © 2010, Juniper Networks, Inc.696
JunosE 11.2.x BGP and MPLS Configuration Guide