pseudowires
associating an ATM port with
before configuring cell
concatenation.................................................528
before configuring VCI/VPI ranges..............528
configuration on both ends of the
matching in the VP/VCI range........................525
not matching in the VPI/VCI range..............525
failure detection
change of state on the ATMx port...............526
multiple ATM virtual circuits
and emulation of connectivity between
two ATM ports.................................................524
transportation of multiple ATM virtual circuits
over a single wire.................................................524
using a single wire for multiple VCs transport
topology example..............................................559
PWid FEC element TLV, for VPLS with LDP
signaling..............................................................................580
R
rd command...........................................................................424
reachability
verify and troubleshoot MPLS................................244
reconvergence of BGP/MPLS VPN networks,
fast........................................................................................454
redistribute command..........................................................54
redistribution routes
disable dynamic (BGP)...............................................54
refresh messages, MPLS...................................................240
refresh-period command.........................................279, 281
remote-neighbor command............................................484
reoptimization and backup...............................................252
reset BGP sessions................................................................96
Response Type field
contained in echo requests
echo response from egress nodes...............249
without P2MP Responder Identifier TLV in
echo requests..................................................249
controlling MPLS echo responses........................250
RFC 4364—BGP/MPLS IP Virtual Private Networks
(VPNs) (February
2006)....................................15, 216, 393, 402, 405, 408
RFC 4816—Pseudowire Emulation Edge-to-Edge
(PWE3) Asynchronous Transfer Mode (ATM)
Transparent Cell Transport Service (February
2007)......................................................................................511
RIB (routing information base)
core non-VPN RIB.......................................................430
core VPN RIB.................................................................430
disabling RIBs-Out........................................................34
rib-out disable command....................................................43
route distinguisher...............................................................389
route interface command..............................531, 532, 538
prerequisite for configuring
cell concatenation parameters for ATM
ports....................................................................528
route interface tunnel command
prerequisite for configuring
VCI/VPI range for ATM VCs
transmission.....................................................527
route maps, BGP.......................................................................71
assigning neighbor weights.......................................110
filtering incoming/outgoing routes..........................88
setting local preferences............................................114
route reachability information, BGP/MPLS
VPN........................................................................................413
route reflectors.......................................................................145
route target
defining BGP/MPLS VPN..........................................425
route targets
configuring VPN topologies....................................409
export list.......................................................................389
for VPN topologies.....................................................409
import list.......................................................................389
route- refresh message , BGP...............................................8
route-map command............................................................75
route-refresh capabilities...................................................123
route-target address family......................................43, 384
route-target command......................................................425
route-target extended community.................................413
route-target filtering, advertisement rules
with.........................................................................................413
route-target filters.................................................................413
route-target membership attribute................................413
router commands
router bgp...........................................18, 439, 596, 656
router ospf.....................................................................604
routes
BGP........................................................................................9
conditionally advertising BGP....................................61
processing of received routes for BGP/MPLS
VPNs............................................................................459
redistributing into BGP.................................................53
using BGP........................................................................153
routing and forwarding instance. See VRF
701Copyright © 2010, Juniper Networks, Inc.
Index
To Next Page
Loading...