Juniper JUNOSE 11.2.X BGP AND MPLS - Page 740

subset of ATM virtual circuits
transportation over a single pseudowire
configuring and....................................................525
summary refresh messages, MPLS..............................240
summary-only keyword (aggregate-address).............61
support, technical See technical support
switch, 802.3ad....................................................................539
synchronization
enabling BGP..................................................................131
LDP-IGP..........................................................................258
synchronization command................................................133
T
table-map command
BGP.....................................................................................80
targeted hellos and LDP extended discovery............250
targeted sessions, for VPLS with LDP
signaling..............................................................................580
technical support
contacting JTAC..........................................................xxxv
test bgp ipv6 command.....................................................154
test ip bgp neighbor command..............................103, 154
text and syntax conventions..........................................xxxiv
timers bgp command...........................................................39
topology-driven LSPs, MPLS...........................................255
trace mpls commands
for detection of data plane failures
at egress nodes in point-to-multipoint
LSPs....................................................................248
trace mpls ip..................................................................244
trace mpls l2transport...............................................244
trace mpls l3vpn..........................................................244
trace mpls rsvp tunnel...............................................244
trace mpls vpls.............................................................244
traceroute requests
in point-to-multipoint LSPs
no additional configuration needed............248
processed the same way as ping
requests.............................................................248
tracing the path to egress nodes..................248
responses to
and ping feature in point-to-multipoint
LSPs....................................................................248
sent by ingress nodes
in point-to-multipoint LSPs...........................248
transit service............................................................................12
transparent bridging and VPLS.......................................576
transport virtual router, configure for VPLS...............590
transportation of multiple ATM VCs
over a single pseudowire
and VPI/VCI ranges............................................525
trigger delay............................................................................297
troubleshooting
BGP....................................................................................157
ttl command..........................................................................484
TTL processing, MPLS
expiration rules.............................................................226
in the platform label space......................................222
tunnel commands
tunnel destination.............................................283, 285
tunnel mpls commands
tunnel mpls affinity...........................................283, 285
tunnel mpls autoroute announce...............283, 285
tunnel mpls autoroute metric......................283, 285
tunnel mpls bandwidth..................................283, 285
tunnel mpls description..................................283, 285
tunnel mpls diff-serv phb-id....................................312
tunnel mpls fast-rerout.............................................297
tunnel mpls lsp retries.....................................283, 285
tunnel mpls lsp retry-time.............................283, 285
tunnel mpls no-route retries.........................283, 285
tunnel mpls no-route retry-time.................283, 285
tunnel mpls path-option............283, 285, 287, 288
tunnel mpls priority..........................................283, 285
tunnels
IPv6 over IPv4 BGP/MPLS VPNs...........................476
U
unicast hop popping, MPLs..............................................220
unicast IPv4 address family............................43, 150, 384
unicast IPv6 address family............................43, 150, 384
update-source command................................................485
updates, BGP
AS-path filters for..........................................................85
in indirectly connected networks.............................32
message explanation......................................................7
minimum interval between sending.......................58
V
VCC (virtual channel connection) cell relay
encapsulation, ATM
configuring.....................................................................535
overview...........................................................................518
Copyright © 2010, Juniper Networks, Inc.704
JunosE 11.2.x BGP and MPLS Configuration Guide