Keysight Technologies B2961A - *RCL

3- 10 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Common Commands
*RCL
*RCL
This command restores the instrument to a state that was previously stored in one of
the memory locations 0 through 9 with the
*SAV command.
Syntax *RCL memory
Parameter memory One of the memory locations 0 to 9. Parameter data type is NR1.
Remarks The device state stored in the location 0 is automatically recalled at power turn-on
when the Output Power-On state is set to *RCL 0.
You cannot recall the instrument state from a storage location that is empty or was
deleted. You can only recall a state from a location that contains a previously stored
state.
The *RST command does not affect the configurations stored in memory. Once a
state is stored, it remains until it is overwritten or specifically deleted.