4- 24 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Commands
LXI Subsystem
LXI Subsystem
:ARM:LXI:COUNt
B2961A/B2962A ignores this command. Specifies an integer as the number of times
the arm has to occur to complete the arm loop; that is, the number of arms that are
accepted before the measurement must be initiated again. intRepetitions must be
greater than zero (0) and is limited by either your application or the maximum 32 bit
signed integer value.This is not enforced by LxiMiddleware; your SCPI action for
this command will need to enforce the limits.
NOTE The LXI Middleware only stores this value. In other words, you essentially have to
implement the count (e.g., you need to keep track of how many ARM events have
occurred, and only arm the instrument when the total COUNt has occurred).
Syntax :ARM:LXI:COUNt intRepetitions
:ARM:LXI:COUNt?
Parameter intRepetitions Number of arms required to complete the arm loop. Parameter
data type is NRf.
Query response intRepetitions <newline>
intRepetitions returns the number of arms required to complete the arm loop.
Response data type is NR1.
Example :ARM:LXI:COUN 10
:ARM:LXI:COUN?
:ARM:LXI:DELay
Specifies the delay, in seconds, from when the arm logic satisfied until the waiting
for trigger state is entered.
NOTE Any <delay> value other than 0.0 is changed to 0 (zero) and a warning is inserted
into the SCPI error queue.
To Next Page
Loading...
Need help?
General
