Keysight Technologies B2961A Command Reference

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 4- 39
Subsystem Commands
LXI Subsystem
The event is added by :LXI:EVENt[:OUTPut]:LAN:ADD.
Syntax :LXI:EVENt[:OUTPut]:LAN:REMove strLanEvent
Parameter strLanEvent LAN event name. String enclosed in quotes. Parameter data
type is SPD.
Example :LXI:EVEN:LAN:REM “MyEvent”
:LXI:EVENt[:OUTPut]:LAN:SEND
Forces the instrument to send the specified output event. The output event must be
enabled, otherwise this command is ignored; in other words, you must send
:LXI:EVENt[:OUTPut]:LAN[:SET]:ENABle <strLanEvent>, ON to enable the
lanEvent prior to sending SEND, or SEND will not send anything.
Syntax :LXI:EVENt[:OUTPut]:LAN:SEND strLanEvent,type
Parameter strLanEvent LAN event name. String enclosed in quotes. Parameter data
type is SPD.
type Event type. RISE|FALL. Parameter data type is CPD.
Example :LXI:EVEN:LAN:SEND “LAN0”,FALL
:LXI:EVENt[:OUTPut]:LAN[:SET]:CONFigure
Configures the most common attributes of LXI LAN output events. The parameters
are also available from their corresponding commands. For more details on the
configurable parameters, refer to the individual SCPI commands below.
Syntax :LXI:EVENt[:OUTPut]:LAN[:SET]:CONFigure strLanEvent, enable, source,
slope, drive, destination
Parameter strLanEvent LAN event name. String enclosed in quotes. Parameter data
type is SPD.
enable Status. 0|OFF|1|ON. Parameter data type is boolean.
source Event name, should be one of following. Parameter data type is
SPD.
• WaitingForAcquireArm1

Keysight Technologies B2961A Specifications

General

Brand	Keysight Technologies
Model	B2961A
Category	Portable Generator
Language	English