Keysight Technologies B2961A - SOURce Subsystem; [:SOURce]:ARB:COUNt; [:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:EN D[:LEVel]

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 4- 101
Subsystem Commands
SOURce Subsystem
SOURce Subsystem
For the numeric suffixes [c], [i], and [n], see “Numeric Suffix” on page 1-8.
[:SOURce]:ARB:COUNt
Sets the number of arbitrary waveforms for the current or voltage output.
Syntax [:SOURce[c]]:ARB:COUNt data
[:SOURce[c]]:ARB:COUNt? [data]
Parameter data Waveform count. value (1 to 100000 or 2147483647)|INFinity|
MINimum|MAXimum|DEFault (default is 1). Parameter data
type is NRf+. value=2147483647 indicates infinity.
Query does not support data=value and INFinity.
data must be less than 100001.
Query response response <newline>
response returns the present setting. If a parameter is specified, response returns the
value assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :ARB:COUN 1
:SOUR2:ARB:COUN?
[:SOURce]:ARB:<CURRent|VOLTage>:EXPonent:EN
D[:LEVel]
Sets the end level of the current or voltage exponential waveform output.
Syntax [:SOURce[c]]:ARB:<CURRent|VOLTage>:EXPonent:END[:LEVel] data
[:SOURce[c]]:ARB:<CURRent|VOLTage>:EXPonent:END[:LEVel]? [data]
For <CURRent|VOLTage>, specify CURRent for current output or VOLTage for
voltage output.