4- 198 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Commands
TRIGger Subsystem
Parameter delay Trigger delay, in seconds. value (0 to 100000)|MINimum|
MAXimum|DEFault (default is 0). Parameter data type is
NRf+. Query does not support delay=value.
Query response response <newline>
response returns the present setting of trigger delay. If a parameter is specified,
response returns the value assigned to DEF, MIN, or MAX. Response data type is
NR3.
Example :TRIG:DEL 0.1
:TRIG2:TRAN:DEL?
:TRIGger<:ACQuire|:TRANsient|[:ALL]>[:IMMediate
]
Sends an immediate trigger for the specified device action to the specified channel.
When the status of the specified device action is initiated, the trigger causes the
specified device action.
Syntax :TRIGger<:ACQuire|:TRANsient|[:ALL]>[:IMMediate] [chanlist]
For <:ACQuire|:TRANsient|[:ALL]>, specify :ACQuire for measurement,
:TRANsient for source output, or :ALL for both device actions.
Parameter chanlist Channels. Parameter data type is channel list.
(@1)|(@2)|(@1,2)|(@1:2)|(@2,1)|(@2:1). See
“Channel List
Parameter” on page 1-8.
(@1) selects channel 1 only. (@2) selects channel 2 only. (@1,2), (@1:2), (@2,1),
and (@2:1) selects both channels 1 and 2.
If this parameter is not specified, chanlist=(@1) is set.
Example :TRIG:ACQ (@2)
:TRIGger<:ACQuire|:TRANsient|[:ALL]>:SOURce:L
AN
Specifies one or more LXI triggers used for the trigger source for the specified
device action.
Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:SOURce:LAN lan_id{,lan_id}
To Next Page
Loading...
Need help?
General
