Keysight Technologies B2961A - SOURce Subsystem

2- 6 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Command Summary
Setting Source Output and Measurement
Table 2-1 SOURce Subsystem
Command Summary Reset setting
[:SOUR[c]]:ARB:COUN count
[:SOUR[c]]:ARB:COUN? [DEFault|
MINimum|MAXimum]
Sets the number of arbitrary waveforms
for the current or voltage output.
count=DEFault|MINimum|MAXimum|
INFinite| 1 to 100000
1
[:SOUR[c]]:ARB:CURR:EXP:END[:LEV
] level
[:SOUR[c]]:ARB:VOLT:EXP:END[:LEV
] level
[:SOUR[c]]:ARB:CURR:EXP:END[:LEV
]?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:EXP:END[:LEV
]?
[DEFault|MINimum|MAXimum]
Set the end level of the exponential
waveform output.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
[:SOUR[c]]:ARB:CURR:EXP:STAR[:LE
V] level
[:SOUR[c]]:ARB:VOLT:EXP:STAR[:LE
V] level
[:SOUR[c]]:ARB:CURR:EXP:STAR[:LE
V]?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:EXP:STAR[:LE
V]?
[DEFault|MINimum|MAXimum]
Set the start level of the exponential
waveform output.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
[:SOUR[c]]:ARB:CURR:EXP:STAR:TIM
E time
[:SOUR[c]]:ARB:VOLT:EXP:STAR:TIM
E time
[:SOUR[c]]:ARB:CURR:EXP:STAR:TIM
E?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:EXP:STAR:TIM
E?
[DEFault|MINimum|MAXimum]
Set the start time of the exponential
waveform output. Waveform period must
not exceed 1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0