Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 63
Subsystem Command Summary
Reading Source/Measure Data
Table 2-16 TRACe Subsystem
:CALC[c]:MATH[:EXPR]:NAME name
:CALC[c]:MATH[:EXPR]:NAME?
Selects a math expression used for
calculation.
name: Up to 32 ASCII characters without
any control characters, space characters,
single and double quotes, and comma.
“POWER”
:CALC[c]:MATH:STAT mode
:CALC[c]:MATH:STAT?
Enables or disables the math expression.
mode=1|ON|0|OFF
OFF
:CALC[c]:MATH:UNIT name
:CALC[c]:MATH:UNIT?
Defines the unit name for the math
expression.
name: Up to 32 ASCII characters.
“W”
Command Summary Reset setting
:TRAC[c]:CLE
Clears the trace buffer of the specified
channel. This command is effective when
the trace buffer control mode is set to
NEV by the :TRAC[c]:FEED:CONT
command.
:TRAC[c]:DATA? [offset[,size]]
Returns the data in the trace buffer.
offset=CURRent|STARt|0 to maximum
size=1 to maximum
:TRAC[c]:FEED type
:TRAC[c]:FEED?
Specifies the data placed in the trace
buffer. This command is effective when
the trace buffer control mode is set to
NEV by the :TRAC[c]:FEED:CONT
command.
type=MATH|SENSe
SENS
:TRAC[c]:FEED:CONT mode
:TRAC[c]:FEED:CONT?
Selects the trace buffer control.
mode=NEXT|NEVer
NEV
Command Summary Reset setting
To Next Page
Loading...
