4- 150 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Commands
SOURce Subsystem
Syntax [:SOURce[c]]:WAIT:GAIN gain
[:SOURce[c]]:WAIT:GAIN? [gain]
Parameter gain value (0 to 100)|MINimum|MAXimum|DEFault (default is 1).
Parameter data type is NRf. Query does not support gain=value.
Query response gain <newline>
gain returns the present setting of the gain value. If a parameter is specified, gain
returns the value assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :WAIT:GAIN 0.5
:SOUR2:WAIT:GAIN?
[:SOURce]:WAIT:OFFSet
Sets the offset value used for calculating the source wait time for the specified
channel. See
[:SOURce]:WAIT[:STATe].
Syntax [:SOURce[c]]:WAIT:OFFSet offset
[:SOURce[c]]:WAIT:OFFSet? [offset]
Parameter offset value (0 to 1 seconds)|MINimum|MAXimum|DEFault (default
is 0). Parameter data type is NRf. Query does not support
offset=value.
Query response offset <newline>
offset returns the present setting of the offset value. If a parameter is specified, offset
returns the value assigned to DEF, MIN, or MAX. Response data type is NR3.
Example :WAIT:OFFS 0.5
:SOUR2:WAIT:OFFS?
[:SOURce]:WAIT[:STATe]
Enables or disables the source wait time for the specified channel. This wait time is
defined as the time the source channel cannot change the output after the start of a
DC output or the trailing edge of a pulse.
Syntax [:SOURce[c]]:WAIT[:STATe] mode
To Next Page
Loading...
Need help?
General
